|
|
|
|
|
- Boom reach is 13.5' (4.11 m) up, 13.2' (4.02 m) out and 7'10" (2.38 m) down
- Flail head cuts 39" (1 m)
|
|
- Two-piece boom arms use parallel linkage
- Inner arm is made of 4" (10.16 cm) x 4" (10.16 cm) x 1/4" (0.64 cm) A50 grade square steel tubing
- 1-1/2" (3.81 cm) x 9-3/16" (22.34 cm) kingpin with tensile strength of 100,000 PSI
- Strong cutter head is made of 11 gauge steel
- Side skirts are made of 1/4" (0.64 cm) steel
- Cutter head deck rotates 220°
- Cuttershaft is 3-3/16" (8.1 cm) OD x 5/16" (0.79 cm) wall; uses 2-3/16" (5.56 cm) bearings; rotation is 2750 RPM
- Flail cutter motor drive is direct and protected by auto pressure relief
- Flail cutter has 20 drop-forged, double-edged knives
- Flail cutter has front and rear rubber deflectors
|
|
- Kingpin has replaceable and greaseable bushings
- Boom retracts to within the front width of the tractor for convenient transportation
|
|
- Single pin release system
- Base is circular facet bent design with dual stage deflector hood
- Tapered for cleaner discharge
|
|
- Hydraulic breakaway point; oil pressure allows the flail head to pivot back when it meets an obstruction
- Hydraulic reservoir contains 24 gallons (90.85 liters) of fluid; uses a 100-mesh screen on suction line with 10-micron filtered return line with a low capacity of 26 GPM; bypass valve is set at 15 PSI
- Tandem hydraulic pumps are used; first stage is dedicated to mower head and has flow rate of 22 GPM at 3000 PSI; second stage is dedicated to boom and has a flow rate of 6 GPM at 1800 PSI
- Hydraulic controls are integrated to the HOLDER tractor; one-hand control joystick
- Dipper arm has 45° hydraulic relief with auto reset
|
